Filter
Top Products
332 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
Examples — The following example verifies the fingerprint for
Distributed MAP 8:
WX4400# set dap 8 fingerprint
b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
See Also
set dap security on page 345
set service-profile cipher-wep40 on page 380 on page 391
display {ap | dap} status on page 304
set {ap | dap} group Configures a named group of MAP access points. MSS automatically load
balances sessions among the access points in a group. To balance the
sessions, MSS rejects an association request for an access point’s radio if
that radio has at least four more active sessions than the radio of the
same type with the least number of active sessions within the group.
Syntax —
set {ap port-list | dap dap-num | auto} group name
ap port-list — List of MAP access ports to add to the group.
dap dap-num — Number of a Distributed MAP to add to the group.
dap auto — Configures a MAP group for the MAP configuration
profile. (See set dap auto on page 325.)
name — MAP access point group name of up to 16 alphanumeric
characters, with no spaces.
Defaults — MAP access points are not grouped by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Usage — You can assign any subset or all of the MAP access points
connected to an WX switch to a group on that switch. All access points in
a group must be connected to the same WX switch.