Filter
Top Products
set radio-profile auto-tune channel-config 349
Defaults — Active scanning is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The command takes effect only on that switch.
Examples — The following command disables active scan in radio profile
radprof3:
wx4400# set radio-profile radprof3 active-scan disable
success: change accepted.
set radio-profile
auto-tune
channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the
MAP radios in a radio profile.
Syntax —
set radio-profile name auto-tune channel-config
{enable | disable}
name — Radio profile name.
enable — Configures radios to dynamically select their channels
when the radios are started.
disable — Configures radios to use their statically assigned channels,
or the default channels if unassigned, when the radios are started.
Defaults — Dynamic channel assignment is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you disable RF Auto-Tuning for channels, MSS does not
dynamically set the channels when radios are first enabled and also does
not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to
manually change channels.