Filter
Top Products
396 CHAPTER 12: STP COMMANDS
vlan vlan-id — VLAN name or number. MSS resets the cost for only
the specified VLAN.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — MSS does not change a port’s cost for VLANs other than the
one(s) you specify.
Examples — The following command resets the STP cost for port 2 in
VLAN sunflower:
WX4400# clear spantree portvlancost 2 vlan sunflower
success: change accepted.
See Also
clear spantree portcost on page 394
display spantree on page 398
display spantree portvlancost on page 403
set spantree portcost on page 414
set spantree portvlancost on page 417
clear spantree
portvlanpri
Resets to the default value the priority of a network port or ports for
selection as part of the path to the STP root bridge, on one VLAN or all
VLANs.
Syntax —
clear spantree portvlanpri port-list {all | vlan
vlan-id}
port-list — List of ports. The port priority is reset to 32 (the default)
on the specified ports.
all — Resets the priority for all VLANs.
vlan vlan-id — VLAN name or number. MSS resets the priority for
only the specified VLAN.
Defaults — None.
Access — Enabled.