Filter
Top Products
ENGLISH
10
E 3M 1997
3M
Multimedia Projector MP8660
Adjusting the Projector Elevation
The elevation can be adjusted by turning the foot adjuster (Figure 3-16) to raise or lower the angle of the
projector.
Figure 3-16. Foot Adjusters
Note
Both adjusting feet must be raised or lowered the
same amount to project a level image on the
viewing screen. The elevation can be adjusted
from approximately 0.4 to 7.2 degrees.
Rear Projection
A semi-transparent screen (Figure 3-17) can be used to project an image and view it from the backside of the
viewing screen. For this type of installation, the image must be horizontally inverted.
Viewing
Side
The projected light beam has
an of
f-center ratio of 80%
above and 20% below the
center of the lens.
90
Figure 3-17. Rear Projection Viewing
3-3. Now What?
Your MP8660 is now connected and ready to power on. Turn to Section 4 for details on operating the
projector.