Filter
Top Products
ENGLISH
6
E 3M 1997
3M
Multimedia Projector MP8660
Power Connection
!
Caution
To prevent damage to equipment, all power to the
MP8660 and input sources must be turned OFF
during cable hook up.
The power cord (Figure 3-3) is detachable from the
projector and has different connection plugs on each
end. Plug the female end into the power cord terminal
on the projector and the male end into a properly
grounded electrical outlet.
Figure 3-3. Connecting the Power Cord
Computer (RGB) Input Connection
There are two input jacks available for connecting either desktop or laptop computers. Find the cable that fits
your computer type. The VGA cable (Figure 3-4) fits IBMt PC and compatible VGA video systems, and the
MAC Adaptor (Figure 3-5) fits on the end of the VGA cable and adapts it to fit AppletMacintosh computers
and Applet Powerbook laptop computers.
Figure 3-4. IBM Compatible Computer Figure 3-5. Apple Macintosh Computer
MAC Adapter Switch Settings
The MAC Adaptor has six switches which must be set for the resolution output of the monitor. Set all
switches to OFF position, then set switches to ON according to the table below:
Resolution Switch ON
640 x 480 (67 Hz) 1, 2
640 x 480 (60 Hz)
800 x 600
3, 4
832 x 624 2, 4
1024 x 768 2, 3
17 inch Multiscan 1, 2, 5
ON
OFF
Figure 3-6. MAC Adaptor Switches
Monitor Loop-Through For IBM Compatible Computers
This connection applies to RGB output only. Video input signals are not compatible with the monitor output
connection.
a Power down the computer
b Connect the monitor cable to the RGB output
port on the projector.
c Turn the power on.
d Select the appropriate RGB input mode on
the projector.