Filter
Top Products
Chapter 4 - Installing Optional Components 4-19
4. Connect the 3-pin cable to JPX1 and the 2-pin cable to JP8 on the system board.
Figure 4-19 Installing the Pentium II CPU
The heatsink becomes very hot when the
system is on. NEVER touch the heatsink with
any metal or with your hands.
4.7.3 Installing the Celeron CPU
Observe the ESD precautions when installing or
removing a system component. See section 4.1.1
Before you proceed, make sure that there is no processor installed in the CPU connector.
Follow these steps to install a Celeron processor:
JPX1
JP8