Filter
Top Products
5 Solving Problems
94
persists, try a different cable.
• Make sure the hub port is configured for the same duplex mode as
the network controller.
• Check with your LAN administrator about the correct networking
software that needs to be installed.
• If you are directly connecting two servers (no hub), you will need a
crossover cable (see your hub documentation for more
information on crossover cables).
• Check the network controller LEDs that are visible through an
opening at the system back panel.
BS811.f/cppl!!Qbhf!:5!!Uvftebz-!Opwfncfs!37-!3113!!21;19!BN