Filter
Top Products
42
4
(1) Disassemble the screw*6(Hex
#4-40*L6), then take off the
R/C.(Figure1).
(2) Disassemble the screw*5
(M3*L6) and loos the wires
connecting the engine and the
MB.
(3) Take off the SHD of the main
board.(Figure2)
screw
driver
5
(1) Extract all the wires in the
mainboard and loose the wire in
clips.(Figure1/2)
(2) Take off the ourlet case and
the Fans*2.
(3) Take off the main board.
Attention: DON'T TWIST THE
PIN UNDER THE M/B.
screw
driver
1 2 3 4
5 6
Figure1
3
4
5
2
1
Figure2
loose these wires
CW
3pin
blower wire
twins fan wire
outlet speaker wire
CW wire
ballast
5pin wire
speaker
wire
IR wire
inlet fan
wire
Figure1 Figure2
Note:
Circuit boards > 10cm
2
has been highlighted with the yellow
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
6
(1) Dismantle the screws*2
(M3*L6) to loose the EXTENSION
BD.(Figure1)
(2) Dismantle the STAND
OFF(M3 D6*9L) and screws*2
(M3*L6) on M/B.(Figure2,3)
screw
driver
Note:
Circuit boards > 10cm
2
has been highlighted with the yellow
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
EXTENSION BD
Figure1
Figure2
Figure3