Filter
Top Products
43
7
(1) Dismantle the screws *2
(M3*L6) to loose the two
wires.(Figure1)
(2) Dismantle the Grounding
screw (M4*L6) in the shield and
loose the Grounding wire.
(Figure2)
8
(1) Dismantle the screws*4
(M3*L8) connecting the PB shield
and the L/C, then take off the
shield. (Figure1)
(2) Take off the inlet case
following the way indicated
below.(Figure2), then extract all
the wires in the power board.
screw
driver
9 (3) Take off the power board.
Figure1
Figure2
1
2
3
4
Figure2
Figure1
Note:
Circuit boards > 10cm
2
has been highlighted with the yellow
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
Figure3
At first, push here. (Take apart
inlet case)
Along arrow, pull inlet
case and can take
apart inlet case.
S5201/5201B
S5301WB
10
(1) Extract the white lamp wire in
the lamp box, and disassemble
the screw*1(M3*L6) connecting
the lamp module in the machine,
then take off the lamp module.
(Figure1)
(2) Dismantle the screw*2(M3*L6)
of the BKT in the neck of the
engine and take off the
BKT.(Figure2)
screw
driver
Figure 1
screw
lamp wire
Figure 2
1
2