Filter
Top Products
B-3
Windows NT Specific Error Messages and Diagnostics
Diagnostics Error Messages
Diagnostic error messages appear at the command line when
running the
aatmdiag.exe
program.
ioctl link failure An error was encountered while doing
I_PLINK or I_PUNLINK between
aarp.sys
,
and
atmo.sys
drivers.
Value <value> out of
bounds
The value in the configuration file is out of
bounds.
Diagnostic Error Message Description
Error: Invalid loop
count entered. Must be
positive integer number
A negative or zero loop count is invalid for
the
loop
command.
Error: Unable to setup
diagnostics. Check if
atmo driver is busy
The driver is busy; several possible causes are
listed below:
Another application is using the
atmo.sys
driver (another
aatmdiag.exe
is currently
active). Terminate the application using the
atmo.sys
driver. For Classical IP, use
acipcnfg.exe
. For an active ARP, use
net stop aarp
.
An invalid controller number was specified
while invoking
aatmdiag -c #
. Valid controller
numbers range from
0
to
N
, where
N
is equal
to the total number of physical boards in the
system minus 1. Only one adapter is
supported in a system at this time (enter
0
).
The
atmo.sys
driver was not loaded properly.
Reconfigure the driver or reinstall the driver.
SYSTEM Error: No such
file or directory File: X
The file does not exist when using the
aatmdiag
-f X
option. Make sure this file exists.
Error Message Description