Filter
Top Products
4-3
Installing ATM Version 4.0x Software for Windows NT
Set the editable parameters in the table below (as required),
and select OK when complete.
To change the NIC configuration, select the NIC Config
button.
Parameter Setting
ELAN Number This read-only field contains the
number automatically assigned to the
LAN during installation. The
ANA-5910/5930/5940 supports up to
four emulated LANs, numbered 0–3.
Driver Version Displays the current version of the
Adaptec LANE driver.
Server Type Select lecs if the server is a
Configuration Server; select les if the
server is a LAN Emulation Server.
MTU Size Stands for maximum transfer unit.
Select 9234 or 1516. Note that 9234
works only if the LES and BUS for this
ELAN also support this selection.
Server ATM Address Enter the ATM address of the LECS or
of the LES; 20 digit (hex) address,
separated by dots (.). The default
setting is WELL-KNOWN LECS
ADDRESS.
LAN Type Select 802.3 if the Ethernet LAN
emulation is to be enabled in the
LANE driver; select 802.5 if Token-
ring LAN emulation is to be enabled.
Peak Cell Rate The default is the Line Rate of the
NIC. The PCR can be stepped down
from the Line Rate. This value is
specified in Mbits/second.
ELAN Name This field is optional. Specify a
character string if the switch supports
this feature. No [space] characters are
allowed in the string.