Filter
Top Products
6-1
6
▼▼▼▼
Installing ATM Software for
DOS/Windows 3.1
This chapter describes how to install and configure Adaptec ATM
software for DOS/Windows 3.1. In addition, this chapter provides
information on using frame types with Novell NetWare.
Configuring the Novell NetWare Client Kit for
DOS/Windows
This section explains how to configure the Novell NetWare Client
Kit for DOS/Windows to support Adaptec’s ATM software.
To configure the NetWare Client Kit
1
Start the Novell NetWare Client installation, as explained in
your Novell NetWare user documentation.
2
In the NetWare Client Install screen, select
OTHER DRIVERS
when prompted to “Select the driver for your network board,”
and then press
Enter
.
3
Remove the [NWClient] diskette from the floppy disk drive,
insert the
ANA-59x0 DOS WIN
diskette, and press
Enter
.
4
From the Network Board screen, select
DOS ODI2NDI
Enabler
.
There are no configuration options for this driver.
5
Complete the Novell NetWare installation.
6
Reboot your system.