Filter
Top Products
10-9
Duralink64 Failover for NetWare
Assigning the Protocols
You can assign IP or IPX protocols to Failover pairs and stand-alone
ports.
Note: The IPX protocol supports all four frame types and
multiple frame types simultaneously. IP supports either
Ethernet_II or Ethernet_SNAP, but never both at the same
time.
1
In the Main Menu, select Configure Protocols, and then press
Enter
.
2
In the List of Ports/Failover Pairs box, select the Failover pair
or port, and then press
Enter
.
Figure 10-14. List of Ports/Failover Pairs Box
3
In the List of Protocols box, select the protocol for the selected
Failover pair or port, and then press
Enter
.
Figure 10-15. List of Protocols Box
List of Ports / Failover Pairs
1 P Adptsf4
2 P Adptsf5
3 P Adptsf6
4 P Adptsf7
5 P Adptsf8
6 F Marcom
P = Stand-alone Port
F = Failover Pair
List of Protocols
IPX
IP