Adaptec ANA-62000 Network Card User Manual


 
8-14
DuraLAN Fast Ethernet NICs User’s Guide
Adding or Removing Ports
Note: If you add or remove a port to or from a group, any existing
group or port IP address is removed automatically. Keep track of
any IP addresses you plan to use again.
1
In the Duralink64 Port Aggregation window, go to the
Configuration tab.
2
In the Group(s) field, click Create New Group, and then type
the new group name, or select the appropriate group you want
to modify.
To add ports to the group, click the appropriate port from the
Available Adaptec Ports box, and then click
Add
.
To remove ports from the group, click the appropriate port from
the Group Ports box, and then click
Remove
.
3
Repeat step 2 for each appropriate port.
4
To save changes, click Apply.
5
When you are finished, click OK.
6
If SNMP is not set up on the computer, you will receive the
message below. Click OK.
Figure 8-11. This message may be ignored during this installation.