Filter
Top Products
B-13
Troubleshooting Tips
4 It's not clear what should be done from the Failover Setup
Menu. How do I configure the ports?
To install the Duralink64 v4.2 Failover software on NetWare
v4.11 or v4.2, use Setupsf from the Duralink64 v4.2 NetWare
diskette. At the main menu, select Failover, then, Configure
Ports, Set Failover Pairs, Configure Protocols, Install Software
and then Save and Exit. Make sure you follow this sequence
and end with Save and Exit. The Save and Exit function
modifies the autoexec.ncf file so that the Failover software is
loaded each time you boot the server.
5 How do I install Duralink64 v4.2 Failover or Port Aggregation
if I currently have the Duralink64 v4.2 standalone drivers
installed?
The setupsf file is used only when installing and uninstalling
Duralink64 v4.2 Failover or Port Aggregation software. The
Configsf file is also used after installation for changing the
failover configuration.
6 Does Duralink64 v4.2 support Novell's 32-bit client for
Windows 95, Windows 98, or Windows NT?
Yes. However, connecting clients to the NetWare Duralink64
server requires the NDIS driver. Do not use an ODI driver. See
the User's Guide Windows 95, Windows 98, or Windows NT
Installation sections for details.
❒