Filter
Top Products
Chapter 7: Installing the Driver and an Operating System ● 47
Installing with UnixWare
Note: You will need your UnixWare Installation CD to complete this task.
To install the driver when installing UnixWare:
1 Insert the UnixWare Installation CD.
2 Restart your computer.
3 Follow the on-screen instructions to begin the UnixWare installation.
4 When prompted to load more HBA drivers, insert the driver disk, then select Yes . (To load
more HBA drivers, repeat this step.)
5 When all drivers have loaded, select No.
6 Complete the UnixWare installation, following the instructions included with your
operating system.
7 Continue with Managing Your Storage Space on page 55.
Installing with VMWare
Note: You will need your VMWare Installation CD to complete this task.
To install the driver when installing VMWare:
1 Insert the VMWare Installation CD.
2 Restart your computer.
3 Follow the on-screen instructions to begin the VMWare installation.
Note:
The VMWare embedded driver will see the device and install.
4
Complete the VMWare installation, following the instructions included with your
operating system.
Note:
Currently, Adaptec Storage Manager is not supported on VMWare. To create and manage
arrays, use the
ARC utility. See page 57 for more information.
Installing with FreeBSD
Note: You will need your FreeBSD Installation CD to complete this task.
To install the driver when installing FreeBSD:
1 Insert the FreeBSD Installation CD.
2 Restart your computer.
3 When the FreeBSD start screen opens, select 6 to escape to loader prompt.
4 Type
load kernel
.
5 Insert the driver floppy disk.
6 Type
load disk0:aacu.ko
.