Filter
Top Products
Chapter 8: Installing the Driver on an Existing Operating System ● 51
Installing on Windows
To install the driver on Windows:
1 Start or restart Windows.
The Found New Hardware Wizard opens and searches for the driver.
2 Insert the driver disk, select Floppy drive, then click Next.
3 Click Next, then click Next again.
4 Follow the on-screen instructions to complete the driver installation.
5 Remove the driver disk and restart your computer.
6 Continue with Managing Your Storage Space on page 55.
Installing on Red Hat or SUSE Linux
To install the module on Red Hat or SUSE Linux:
1 Insert and mount the RAID Installation CD:
Red Hat:
mount /dev/cdrom /mnt/cdrom
SUSE:
mount /dev/cdrom /media/cdrom
2 Install the module RPM:
rpm -Uvh mount-point/xxx/yyy.rpm
where
mount-point
is the specific mount point on the Linux system,
xxx
is the driver path,
and
yyy.rpm
is the rpm file.
3 Reboot your computer to ensure the driver loaded correctly.
4 Run fdisk, mkfs, and create mount points for any new disk drives.
5 Continue with Managing Your Storage Space on page 55.
Installing on NetWare
Note: Before you begin, ensure that your NetWare operating system has been upgraded to the
minimum patch level specified by Novell. Refer to the Novell Web site for more information.
To install the driver on NetWare:
1 Start your computer.
2 At the NetWare server console prompt, type
load hdetect
,
then press Enter if it has not be
loaded automatically.
3 At the Device types menu, select Continue
,
then press Enter.
4 At the Device type option, select Modify
,
then
press Enter.
5 Select Storage Adapters
,
then
press Enter.
6 At the Additional Driver Options menu, select Modify
,
then
press Enter.
7 If aacraid.ham has already been detected, delete it.