Filter
Top Products
Setting Up the PC To Configure the Modem
18 Megabit Modem 400F User Manual
SETTING UPTHEPC TO CONFIGURE THE MODEM
Configure the Megabit Modem 400F using a PC connected to the 10/100BASE-T port. The PC
must be set to
Specify an IP address to initially access the modem. Enter an IP address for PC NIC
card that is on the same subnet as the IP address for the modem. If you want to view or change
the default IP address for the modem, see “Using the RS-232 Management Port” on page 57.
The following is an example of how to set up the PC using Microsoft Windows
®
95. If you
use an operating system other than Windows 95, refer to the appropriate operating system user
documentation.
1 Open the
Control Panel window and double-click on the Network icon
shown at right.
2 In the Network dialog (shown below), double-click TCP/IP under the
Configuration tab (or highlight TCP/IP then click Properties).
3 In the
IP Address tab, select Specify an IP address.
4 Enter an IP address and subnet mask for the PC, then click OK.
5 Restart the PC.