Filter
Top Products
Configuring RFC 1483 Bridging/Routing Sessions
44 Megabit Modem 400F User Manual
Defining or Modifying Static MAC Entries
You can enter up to 32 static MAC addresses that the modem recognizes in the MAC address
tables. The modem will also learn up to 1024 MAC addresses.
1 Enter Static MAC addresses.
2 Click
Add to accept this entry.
Enter the MAC Address for a device on the LAN. The Mac Address field is case
sensitive and does not accept uppercase alpha characters; use only lowercase alpha
characters (for example, 00:aa:00:46:d6:4c).
Enter a number (1 through 33) for the
Source Port. The port number is 1 when
the source is the modem LAN port. The port number is 2 through 33 when the
source is one of the 32 sessions. For example, if the source port is the second
session set up (or port 2 on the
EasySession page), enter the source port as 3.
The source port number is always one number higher than the port number on the
EasySession page.
Enter a number 1 through 33 for the Destination Port. The port number is 1 when the
destination is the modem LAN port. The port number is 2 through 33 when the
destination is one of the 32 sessions. For example, if the destination port is the
second session set up or port 2 on the
EasySession page, enter the destination port as
3. The destination port number is always one number higher than the port number
on the
EasySession page.
All static MAC address entries are listed in this table after you enter the parameters
in fields
and then Add them.