ADC 410F Network Card User Manual


 
Megabit Modem 410F and 420F User Manual 11
3
INSTALLING THE MEGABIT MODEM
410F AND 420F
The Megabit Modem 410F and 420F are easy to install by:
attaching adhesive-backed feet
setting the MDI/MDI-X switch
connecting a cable from the modem to a PC or an Ethernet hub for LAN service
connecting a phone cord from the modem to a wall phone jack for DMT ADSL Internet or
other types of WAN services
connecting a power cable to a local power outlet
powering up and checking LEDs
Perform the installation described on the following pages (see “Requirements for the
Installation Site” on page 6 to determine where to place modems). Use the parts listed below in
the installation procedures.
Part Function
Rubber feet (four) Attaches to the base of the modem.
Black cable Connects the modem 10/100BASE-T connector to the LAN through a hub
or to a PC NIC.
Grey cord Connects the modem ADSL connector to the RJ-11 wall jack with DMT
ADSL service for access to the Internet or other types of WAN applications.
Power cable Connects the modem POWER connector to the local power source. Power
supply optionally has a power cord. (See “Power Cable Options” on page 9
for selection options.)
Grey cable and
adapter
Connects the RS-232 management port to an ASCII terminal or a PC
running terminal emulation software. The adapter assembly connects to a
DB-9 connector on the PC. One RJ-45 connector installs in the adapter and
the other connector into the console port on the modem.