Filter
Top Products
Chapter 4: Managing the Modem Using the Console Port & Telnet
MM701F User Manual 47
Valid values for the parameters shown on the Sessions Options screen are defined in the
following table. Unless there is a special circumstance, the default values for the remaining
parameters should not be changed.
Session Parameter Valid parameter Values
Session Name The name assigned to the session by your service
provider—up to 15 characters.
WAN Protocol RFC1483-Router, RFC1483-Bridge, PPPoA.
State Enable or Disable a session.
IP Addressing Static or Dynamic. Not applicable to bridging.
IP Address WAN IP address supplied by your service provider.
IP Net Mask WAN IP subnet mask supplied by your service provider.
NAT Enable or Disable.
RIP Send Disable, RIP1, RIP2, Rip1&Rip2.
RIP Accept Disable, RIP1, RIP2, Rip1&Rip2.
VPI VPI supplied by your service provider.
VCI VCI supplied by your service provider.
QoS Supplied by your service provider.
QoS Peak Cell Rate Supplied by your service provider.
Encapsulation Select VC-MUX or LLC.
Login Name PPP authentication name supplied by your service
provider.
Login Password PPP authentication password supplied by your service
provider.
Authentication Select PAP or CHAP.
Apply Apply Settings.