Filter
Top Products
Setting Up the WAN
48 MM701F User Manual
SETTING UPTHELAN
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of 10.0.0.1 for the Ethernet Port IP Address, and
255.255.255.0 for the subnet mask.
1 From the
Main Menu, select LAN Setup. The LAN setup screen displays.
2 From the
LAN Setup menu, select LAN Protocol by typing 1.
3 Do one of the following from the LAN Mode menu:
• Type
1 to select Router.
• Type 2 to select Bridge. You must configure an IP address for the LAN port to use a
Browser or Telnet to manage the MM701F.
4 From the LAN Setup menu, type 2 or 3 to select IP Address or IP Net Mask (respectively), then
enter the values supplied by your LAN administrator or use the default values.
5 From the LAN Setup menu, type 4 to select Default Gateway,thenentertheDefault Gateway IP
address supplied by your access provider.
6 From the
LAN Setup menu, type 10 to select Apply. Apply immediately activates the changes
that you have made for this session.
7 From the Main Menu, type 5 to select Save New System Configuration and save these settings.
LAN
1. LAN Protocol Bridge
2. IP address 10.0.0.1
3. IP Net Mask 255.255.255.0
4. Default Gateway
5. DHCP None
6. DHCP Range Low Address N/A
7. DHCP Range High Address N/A
8. DHCP Gateway Address N/A
9. DHCP DNS N/A
10. Apply
Select Parameter to edit (Return to exit) ->