ADIC DS9000 Series Switch User Manual


 
6
Front Panel Indicators and Controls
2-line by 20-character LCD
Display
Displays drive status, error messages, POST results
Beeper
Sounds whenever it is
OK
to operate the cartridge insert/release handle. The green
Operate Handle LED should be
ON
whenever the Beeper sounds.
Write Protected
(orange)
ON
= Tape write-protected.
OFF
= Tape write enabled.
Tape in Use
(yellow)
Blinking
= Tape moving.
ON
= Tape loaded; ready for use.
Use Cleaning Tape
(yellow)
ON
= Drive head needs cleaning, or the tape is bad.
OFF
= cleaning complete, or cleaning unnecessary.
Operate Handle
(green)
ON
= OK to operate the cartridge insert/release handle.
OFF
= Do not operate the cartridge insert/release handle.
Density Select 2.6
(yellow)
ON
= Tape is recorded in 2.6 GB format.
Blinking
= Tape is recorded in another density.
Density Select 6.0
(yellow)
ON
= Tape is recorded in 6.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 10.0
(yellow)
ON
= Tape is recorded in 10.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 15.0
(yellow)
ON
= Tape is recorded in 15.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 20.0
(yellow) [DS9400D/L, ADIC
4000]
ON
= Tape is recorded in 20.0 GB format.
Blinking
= Tape is recorded in another density.
Density Select 35.0
(yellow) [DS9700D]
ON
= Tape is recorded in 35.0 GB format.
Blinking
= Tape is recorded in another density
Density Select 40.0
(yellow) [DS9800D]
ON
= Tape is recorded in 40.0 GB format.
Blinking
= Tape is recorded in another density
Compress
(yellow)
ON
= Compression mode enabled.
OFF
= Compression mode disabled.
Density Override
(yellow)
ON
= Density selected from front panel.
OFF
(default) = Density selected from host.
Blinking
= In density selection mode.
Unload Button
Pressing this button initiates a manual unload of the tape. This may take from 10
seconds to 4 minutes depending on tape position.
Cartridge Insert/Release
Handle
Lift this handle (only when the Operate Handle LED is
ON
, and after the
momentary beep sounds) to load or eject a cartridge from the drive. The handle lifts
to the open position and lowers to the closed position.