Filter
Top Products
Chapter 3 Hardware and Peripheral Installation
25
7. Next, install an SDRAM module. Slip the memory module into the
socket at a 45 degree angle as shown in Figure 3-9.
Figure 3-9: Installing the memory module
8. Push the module toward the horiontal ports at both ends of the
socket until the module is upright and the retaining clips at both ends
of the module click into place. When positioned correctly, the pins on
top of the vertical posts should correspond to the circular holes on the
ends of the module.
9. If a second 144-pin SODIMM socket is requested to install a second
memory module, please follow Appendix B to disassemble the panel
PC, then repeat steps 7 and 8 for each module you install.
10. Finally, put the heat sink back and tighten the six screws to fix it as
shown in Figure 3-3.