Filter
Top Products
106
5.4.2 MAC Filter Setup
Allows to create MAC filter rules to allow or deny unicast or multicast packets from limited number of MAC addresses.
Important to note that MAC filter rules have precedence over IP Filter rules.
Please click on Advance -> MAC Filter Setup and follow the below setting.
MAC Filter Rule : By default, it’s “Disable”. Options are Disabled, Only Deny List MAC or Only Allow List MAC. Click
Save button to save your change.
Two ways to set the Access Control List:
Î Only Allow List MAC.
The wireless clients in the MAC Filter List will be allowed to access to Access Point; All others will be denied.
Î Only Deny List MAC.
The wireless clients in the MAC Filter List will be denied to access to Access Point; All others will be allowed.
MAC Address : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click “Add” button, then the MAC address should
display in the MAC Filter List.
There are a maximum of 20 clients allowed in this MAC Filter List. The MAC addresses of the wireless clients can be added
and removed to the list using the Add and Delete buttons.
Click Reboot button to activate your changes