Filter
Top Products
120
6.2 Access Point Association
6.2.1 Configure Wireless General Setting
The administrator can change the data transmission, channel and output power settings for the system. Please click on
Wireless -> General Setup and follow the below setting.
ESSID : Assign Service Set ID for the wireless system.
Band Mode : Select an appropriate wireless band; bands available are 801.11b, 802.11g and 802.11b+802.11g.
Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from 1 to
54Mbps for 802.11g and 802.11b/g modes, or 1 to 11Mbps for 802.11b mode.
Country : Select the desired Country code from the drop-down list; the options are US, ETSI or Japan.
Channel : The channel range will be changed by selecting different country code. The channel range from 1 to 11 for US
country code, or 1 to 13 for ETSI country code, or 1 to 14 for JP country code.
Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless network.
Select the LEVEL 1 to LEVEL 9 you needed for your environment. If you are not sure of which setting to choose, then
keep the default setting, LEVEL 9.
Security Type : Select the desired security type from the drop-down list; the options are Disabled WEP, WPA-PSK and
WPA2-PSK.
Î Disable : Data are unencrypted during transmission when this option is selected.
Î WEP : Wired Equivalent Privacy(WEP) is a data encryption mechanism based on a 64-bit, 128-bit or 152-bit shared
key. The WEP key configured here must be exactly the same as the key on the access point that this system is
associated with.