Filter
Top Products
117
Chapter 6. Client Bridge + Universal Repeater
Configuration
When Client Bridge + Universal Repeater mode is activated, the system can be configured as an Access Point and Client
Station simultaneously. This section provides information in configuring the Client Bridge + Universal Repeater mode with
graphical illustrations. APO1000/APO1010 provides functions as stated below where they can be configured via a user-
friendly web based interface.
Option System Wireless Utilities Status
Operating Mode General Setup Profiles Settings System Overview
LAN Advanced Setup Firmware Upgrade Clients
Management AP Setup Network Utility DHCP Clients
Time Server MAC FIlter Reboot Extra Info
SNMP Site Survey Event Log
Functions
UPNP
Table 6-1: Client Bridge + Universal Repeater Mode Functions
6.1 External Network Connection
6.1.1 Network Requirement
It can be used as an Client Bridge or Universal Repeater to receive wireless signal over last mile applications, helping WISPs
deliver wireless broadband Internet service to new residential and business customers. In this mode, APO1000/APO1010 is
enabled with DHCP Server functions. The wired clients of APO1000/APO1010 are in the same subnet from Main Base
Station and it accepts wireless connections from client devices.
Figure 6-1 Client Bridge + Universal Repeater mode Configuration
When the APO1000/APO1010 configured as an Access Point and Client Station simultaneously, the Wireless
General and Advanced Setup also used simultaneously. But the Security Type can be different. In the other
word, the channel or other settings will be the same between APO1000/APO1010 to Main Base Station and
wireless client to APO1000/APO1010, but security type can be different.
APO1000/APO1010