Filter
Top Products
1.4. For the ope ra ting sa fe ty of the equip ment
·
Never change settings if the consequences are not precisely known.
·
Use only original Sterlingspare parts.
·
Observe the maintenance instructions.
·
Keep record of all maintenance and repair procedures.
·
Please note that electronic components may be damaged by static discharge.
·
Check all electrical connections for secure fit before the equipment is taken into
operation and at regular intervals.
·
Never adjust sensors without exact knowledge of their function.
·
Please note that the maximum ambient temperature must not exceed 45 °C
(113°F).
·
Align the suction tubes of the individual components equally.
·
Please note that the set conveying ratio determines the conveying time.
·
Please note that compressed air supply is required for the operation of the SKW.
·
Never set a higher operating pressure than 6 bar (87.02 PSI) for the SKW (system
overpressure).
·
Check whether the regrind is connected to the left-hand intake port (1) of the
SKW.
·
Install VA-steel pipe bends when conveying abrasive material (SKW 40,
SKW 50).
046-3MS
SKW
Sa fe ty in struc tions 13