Filter
Top Products
4.3. Set ting the swit ching cy cles
SKW Ver si on 1
Press the percentage key.
By means of the arrow key, set the determined switching cycle.
Check the result.
If the result is not satisfactory, correct the setting.
&
If there are too many switching cycles, proper conveying is
not possible.
SKW Version 2
Set the determined value by means of the control system of the conveying
control.
Observe the operating manual of the conveying control.
Check the result.
If the result is not satisfactory, correct the setting.
046-3MS
SKW
Start-up 32