Filter
Top Products
www.aleratec.com
13
Using the 1:11 HDD Copy Cruiser IDE/SATA
Main Menu
Copy HDD
The “Copy HDD” function performs an actual copy from a source HDD to one or
more target HDDs. The target HDDs must be at least as large as the source. The
1:11 HDD Copy Cruiser IDE/SATA will copy every block of capacity on the source
HDD.
1. Load the source HDD and the target HDDs into the 1:11 HDD Copy Cruiser
IDE/SATA. The system will auto-detect the hard drives. After the drives have
been detected, a screen similar to the one below will be displayed.
Note: Before copying be sure that the capacity of the target HDD is
equal to or larger than the source hard drive.
2. Press ENT to start copying. The system will auto-detect the hard drives. The
following information will be displayed.
3. During the copy process the 1:11 HDD Copy Cruiser IDE/SATA will display
progress information.
The amount of data remaining to be transferred (shown in gigabytes), and time
will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one
source hard drive to another.
ENT ESC
1. Copy HDD
149.1GB
ENT ESC
Detect Drives
Please wait...
ENT ESC
Copy- 36MB/s 0%
235.7GB 1:48