Filter
Top Products
www.aleratec.com
47
Specications
Power Requirements 100V-240V AC, 50/60Hz
Dimensions
(length x width x height)
D: 416mm W: 191mm H: 648mm
Weight 15.9 Kilograms
Note: Specifications subject to change without notice.
Troubleshooting
If your 1:11 HDD Copy Cruiser IDE/SATA is not performing as expected, refer to
the symptoms below, and follow the suggested corrective action.
Symptoms Corrective Actions
LCD Display If the LCD display does not display any message and the
backlight is not lit after powering on the 1:11 HDD Copy
Cruiser IDE/SATA, check that the power cable is properly
connected and that the ON/OFF switch is turned on.
Error Messages While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the 1:11 HDD Copy Cruiser
IDE/SATA to stop responding. If this happens, power the
unit off, wait about ten (10) seconds, and then reapply
power.
Hard Disk If the 1:11 HDD Copy Cruiser IDE/SATA does not detect
one of the hard disk drives, verify that the drive is properly
seated in the drive bay.
Keypad Buttons If pressing the keys on the front panel produces no
response from the system, the 1:11 HDD Copy Cruiser
IDE/SATA may still be busy with the previous operation.
If the system idle, power the unit off, wait about ten (10)
seconds, and then reapply power.
Firmware Update The device can be updated to new versions of rmware via
a hard disc drive. If unable to update the rmware, check
that the rmware was downloaded correctly. A failed
rmware upgrade may cause the 1:11 HDD Copy Cruiser
IDE/SATA to become inoperable. If the system is working
normally, do not attempt this operation. If the system is
already experiencing problems, please contact Aleratec for
repairs.
Startup/Shutdown Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.