Filter
Top Products
www.aleratec.com
15
Using the 1:11 HDD Copy Cruiser IDE/SATA
Main Menu
Async Copy
The function “Async Copy” allows you to insert target drives during the copying
operation. During the process, you can insert another drive as a target of the Async
Copy operation and the unit will automatically copy to this new drive as well.
1. Load the source HDD and the target HDDs into the 1:11 HDD Copy Cruiser
IDE/SATA. The system will auto-detect the hard drives. After the drives have
been detected, a screen similar to the one below will be displayed.
Note: Before copying be sure that the capacity of the target HDD is
equal to or larger than the source hard drive.
2. Press ENT to start copying. The system will auto-detect the hard drives. The
following information will be displayed.
3. During the copy process the 1:11 HDD Copy Cruiser IDE/SATA will display
progress information.
The amount of data remaining to be transferred (shown in gigabytes), and time
will be displayed as the percentage of completion increases.
Note: The copying speed, capacity and duration may vary from one
source hard drive to another.
ENT ESC
2. Async Copy
ENT ESC
Detect Drives
Please wait...
ENT ESC
Copy- 36MB/s 0%
235.7GB 1:48