Filter
Top Products
Page 66
Allied Telesis AT-8000S Switch
Web Browser Interface User’s Guide
– 1000 Full — Indicates that the trunk advertises for a 1000 Mbps speed trunk and full duplex mode
setting.
• Back Pressure — Displays the back pressure mode on the trunk. Back pressure mode is used with half
duplex mode to disable trunks from receiving messages.
• Flow Control — Displays the flow control status on the trunk. Operates when the trunk is in full duplex mode.
– Enable — Indicates that flow control is currently enabled for the selected trunk. This is the default value.
– Disable — Indicates that flow control is currently disabled for the selected trunk.
• MDI/MDIX — Displays the MDI/MDIX status on the trunk. Hubs and switches are deliberately wired opposite
the way end stations are wired, so that when a hub or switch is connected to an end station, a straight through
Ethernet cable can be used, and the pairs are matched up properly. When two hubs or switches are
connected to each other, or two end stations are connected to each other, a crossover cable is used to ensure
that the correct pairs are connected. The possible field values are:
– Auto — Use to automatically detect the cable type.
– MDI (Media Dependent Interface) — Use for end stations.
– MDIX (Media Dependent Interface with Crossover) — Use for hubs and switches.
3. Modify the fields.
4. Click Apply. The Trunk settings are saved and the device is updated.