Filter
Top Products
Configuring Interfaces
Configuring VLANs
Page 81
Enabling/Disabling GVRP on a Port
To modify the GVRP ports:
1. Click Layer 2 > GVRP. The GVRP Page opens.
2. Select Port and Unit or Trunk in the GVRP Port Configuration section.
3. Click Modify. The GVRP Port Configuration Page opens:
Figure 49: GVRP Port Configuration Page
•
Unit Number — The stacking member for which the GVRP parameters are displayed.
• Interface — Displays the port on which GVRP is enabled. The possible field values are:
– Port — Indicates the port number on which GVRP is enabled.
– LAG — Indicates the LAG number on which GVRP is enabled.
• GVRP State — Indicates if GVRP is enabled on the port. The possible field values are:
– Enabled — Enables GVRP on the selected port.
– Disabled — Disables GVRP on the selected port.
• Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on the interface. The possible
field values are:
– Enabled — Enables Dynamic VLAN creation on the interface.
– Disabled — Disables Dynamic VLAN creation on the interface.
• GVRP Registration — Indicates if VLAN registration through GVRP is enabled on the device. The possible
field values are:
– Enabled — Enables GVRP registration on the device.
– Disabled — Disables GVRP registration on the device.
4. Select the interface (Port or Trunk).
5. Define the GVRP State and GVRP Registration fields.
6. Click Apply. The change to the GVRP mode is activated on the selected interface.