Filter
Top Products
Chapter 4: Installing the Switch and its Power Supplies
62
Installing the Power Cord Retaining Clip
This section applies to AC power supply modules.
Perform the following procedure to install the power cord retaining clip on
each power supply module:
1. Locate the power cord retaining clip, shown in Figure 17.
Figure 17. Power Cord Retaining Clip
2. Install the clip on the AC power connector on the power supply
module. With the ‘u’ of the clip facing down, press the sides of the clip
toward the center and insert the short ends into the holes in the
retaining bracket, as shown in Figure 18.
Figure 18. Inserting the Retaining Clip into the Retaining Bracket
You are now ready to install the switches, as explained in the next
procedures.
100-240VAC
~