Filter
Top Products
Configuration
37
Opening the
Configuration
Software
Open the configuration software by double-clicking the “ATS57”
application icon, as you would with any other software program. The AT-
MC60x Configurator pop-up will appear, as shown in Figure 24.
Figure 24 AT-MC60x Configurator
If you would like to verify that you are using the latest version of the
configuration and management software, click the About button on the
bottom right of the AT-MC60x Configurator pop-up. The About AT-
MC60x Configurator pop-up will appear, as shown in Figure 25.
Figure 25 About AT-MC60x Configurator
Select the computer port you are using from the pull-down menu on the
AT-MC60x Configurator pop-up and click OK.
If you are connected to the AT-MC602 Provider unit and want to configure
the network extenders, continue with the next section, ”Configuring the
Provider Unit” on page 38. If you are connected to the AT-MC601
Subscriber unit to attempt link recovery, continue with ”Configuring the
Subscriber Unit” on page 45.