Filter
Top Products
MULTITASKER™
400-0132-005
18
Example:
Group 5 consists of the cards located in slots
number 2, 4 and 6. Remove all cards from the
group by sending the command [RMG5]. The
system will return the following feedback:
[G5=0]
REMOVE ALL GROUPS
Remove all the members from every group,
effectively deleting all groups.
Command Format: [RMG*Ui]
Ui = Unit ID (i = # from 0-9)
Example:
Group 5 consists of cards 2, 4 and 6. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG*].
The system will return the following feedback:
G1-G8:EMPTY
28. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 2, 4 and 6 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (group 5) and then the
cards that make up group 5. In this case,
group 5 includes C2, C4 and C6.
29. [TEST]
This command performs a series of tests on the
internal memory of the card.
Upon completion, the system will display
following:
Command Format: [TESTCn]
Cn = Card ID (n = # from 1 to 99)
Example:
Test the internal memory of the MT110-102 in
slot 4 by sending the command [TESTC4]. The
card will respond with the feedback similar to
the following:
MEMORY IS GOOD
Otherwise, failures would be indicated in the
feedback from the card.
30. [VLO] MT110-102 ONLY
This command sets the absolute volume level
for a given output.
Command Format: [VLOmAvCnUi]
m = Output (m = # from 1 to 8)
v = Volume Level (v = # from 1 to 32)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT110-102 card in slot 8. Set the
output volume on Output 2 to 16 by sending the
command [VLO2A16C8].
31. [SEL] MT110-102 ONLY
This command is the output select command. It
sets the path to adjust the output volume level
for the current matrix. It is used in conjunction
with the [ + ] and [ - ] commands.
Command Format: [SELmCnUi]
m = Input No. (m = # from 1 to 16)
Cn = Engine Card Slot Number
Ui = Unit ID (i = # from 0 to 9)
[+] = Increment level by one
[-] = Decrement level by one