Filter
Top Products
Chapter 2. CLI Syntax Reference
62 3ware Serial ATA RAID Controller CLI Guide
/c
x
/u
x
show initializestatus
This command reports the initializestatus (if any) of the specified unit.
Example:
//localhost> /c0/u5 show initializestatus
/c0/u5 is not initializing, its current state is OK
/c
x
/u
x
show name
This feature only applies to 9000 series controllers.
This command reports the name (if any) of the specified unit.
Example:
//localhost> /c0/u5 show name
/c0/u5 name = Joe
/c
x
/u
x
show serial
This feature only applies to 9000 series controllers.
This command reports the unique serial number of the specified unit.
Example:
//localhost> /c0/u5 show serial
/c0/u5 Serial Number = 12345678901234567890
/c
x
/u
x
show qpolicy
This feature only applies to 9550SX, 9590SE, and 9650SE model controllers.
This command reports the queue policy of the firmware. If the queue policy is
on, the firmware utilizes the drive queueing policy. If some drives in the unit
do not support a queueing policy, this policy will have no effect on those
drives.
Note that currently only NCQ will be enabled, not tag-queueing.
Example:
//localhost> /c0/u5 show qpolicy
/c0/u5 Command Queuing Policy = on