Filter
Top Products
Port Object Commands
www.3ware.com 81
/c
x
/p
x
remove [noscan] [quiet]
This command allows you to remove (or export) a port (or drive) /cx/px.
Exporting a port instructs the firmware to remove the specified port from its
pool of managed ports, but does not retain the DCB (Disk Configuration
Block) metadata on the attached disk. You can import (or re-introduce) the
port by rescanning the controller.
noscan is used to not inform the operating system of this change. The default
is to inform the operating system.
quiet is for non-interactive mode.
/c
x
/p
x
set identify=on|off
This command applies only to 9550SX, 9590SE, and 9650SE model
controllers.
This command sets the LED status of the port to on or off. If identify is set to
on, the firmware activates the setting of the corresponding LED of the port on
the controller and causes it to blink.
Note: This command is equivalent to “/ex/slotx set identify=on|off” on
page 90.
Example:
//localhost> /c0/p5 set identify=on
Setting Port Identify on /c0/p5 to [on] ... Done.
Warning: Use caution when using this command as this operation will degrade
any redundant units. This command will fail if you attempt to remove a drive from a
non-redundant unit. After the drive is removed in CLI it can be removed physically,
without powering down the system if a hot swap carrier is available. System hangs
and damage can occur if a hot swap carrier is not used.
Note: This feature requires an enclosure that uses an integrated AMCC/3ware
CCU (chassis control unit). (Check the 3ware web site for a list of chassis vendors
that support enclosure services, as they become available.)
For additional
information about enclosure-related commands, see “Enclosure Object
Commands” on page 87
.