Filter
Top Products
Chapter 2. CLI Syntax Reference
78 3ware Serial ATA RAID Controller CLI Guide
/c
x
/p
x
show status
This command displays the status of the drive attached to the specified port.
(Definitions of the drive statuses are available in the 3ware Serial ATA RAID
Controller User Guide.)
Example:
//localhost> /c0/p5 show status
/c0/p5 Status = OK
/c
x
/p
x
show model
This command displays the model of the drive attached to the specified port.
Example:
//localhost> /c0/p5 show model
/c0/p5 Model = WDC WD1600BB-00DAA0
/c
x
/p
x
show serial
This command displays the serial number of the drive attached to the
specified port.
Example:
//localhost> /c0/p5 show serial
/c0/p5 Serial = WD-WMACK140649
/c
x
/p
x
show firmware
This command displays the firmware version of the drive attached to the
specified port.
Example:
//localhost> /c0/p5 show firmware
/c0/p5 Firmware Version = 65.13G65
/c
x
/p
x
show identify
This command applies only to 9550SX, 9590SE, and 9650SE model
controllers that have chassis control hardware (enclosure services) attached.
This command shows whether the LED of the drive attached to the specified
port is set to on or off. For details, see “/cx/px set identify=on|off” on page 81.
Example:
//localhost> /c0/p5 show identify
/c0/p5 Identify Status = on