Filter
Top Products
Enclosure Object Commands
www.3ware.com 87
Enclosure Object Commands
Enclosure object commands provide information and perform actions related
to a specific enclosure, such as /e0 and its elements, such as /e0/slot0.
Enclosure object elements include slot, fan, and temperature sensor elements.
These commands are supported on the 9550SX, 9590SE, and 9650SE
controllers, when an appropriate enclosure is used. The enclosure must use an
integrated AMCC/3ware CCU (chassis control unit). (Check the 3ware web
site for a list of chassis vendors that support enclosure services, as they
become available.) If you purchased an enclosure directly from a third-party
vendor, the appropriate EPCT (Enclosure Port Configuration Table) must
have been downloaded to the controller in order to take advantage of these
commands.
Syntax
/ex show (9550SX, 9590SE, 9650SE only)
/ex show attribute [attribute ...] where attributes are:
controllers|slots|fans|temp
/ex show all (9550SX, 9590SE, 9650SE only)
/ex/slotx show (9550SX, 9590SE, 9650SE only)
/ex/slotx show identify (9550SX, 9590SE, 9650SE only)
/ex/slotx set identify=on|off (9550SX, 9590SE, 9650SE only)
/ex/fanx show (9550SX, 9590SE, 9650SE only)
/ex/tempx show (9550SX, 9590SE, 9650SE only)
/ex show
This command shows summary information on the specified enclosure /ex.
This report consists of four parts; the Enclosure summary listing the present
elements, a Fan summary section listing of all present fans, a Temperature
Sensor summary section listing of all present temperature sensors and a Slot
summary section listing of slots and associated information for the specified
enclosure.
Note. Not all enclosure features may be available on enclosures that use an
integrated AMCC/3ware CCU.