Filter
Top Products
Chapter 2. CLI Syntax Reference
90 3ware Serial ATA RAID Controller CLI Guide
/ex/slotx show
This command shows information about the specified /slotx on the specified
enclosure /ex. The slot name is followed by its status. If a slot has been
inserted with a drive and no fault has been detected, the status is OK. If the
slot is empty the status would indicate NO-DEVICE. The port that is
correlated to the slot is indicated in the next column. If no device is found in
the slot, that is indicated with a dash (-) in the Port column. The final column
shows whether “identify” is currently set for the specified slot.
Example:
//localhost> /e0/slot1 show
Slot Status Port Identify
----------------------------------------------------
slot1 OK /c0/p1 Yes
/ex/slotx show identify
This command shows the identify status of the specified slot. The status can
be either on or off.
Example:
//localhost> /e0/slot1 show identify
/e0/slot1 Identify status = on
/ex/slotx set identify=on|off
This command causes the slot to be identified by blinking the LED associated
with it, or turns off identification of the LED for this slot.
Setting identify to on will cause the LED associated with that slot to blink,
provided that the EPCT has been set to associate “identify” with “blinking,”
as is the case in the 3ware Sidecar.
Note: This command is equivalent to “/cx/px set identify=on|off” on page 81.
Example:
//localhost> /e0/slot1 set identify=on
Sending Identify request to Drive Slot /e0/slot0 to [on] ...
Done.