Filter
Top Products
Chapter 2. CLI Syntax Reference
18 3ware Serial ATA RAID Controller CLI Guide for the Power Mac G5
Syntax Overview
The command syntax uses the general form:
Object Command Attributes
Objects are shell commands, controllers, units, ports (drives), BBUs (battery
backup units), and enclosures.
Commands can either select (show, get, present, read) attributes or alter (add,
change, set, write) attributes.
Attributes are either Boolean Attributes or Name-Value Attributes.
• The value of a boolean attribute is deduced by presence or lack of—that
is, the attribute is either specified, or not. For example, the command
show alarms by default lists alarms with the most recent alarm first. If
you include the attribute reverse, as in the command show alarms
reverse, alarms are listed in reverse order.
• The value of name-value attributes are expressed in the format
attribute=value.
Example: When adding (creating) a unit to the controller with the following
command string,
/c1 add type=raid1 disk=0-1
c1 is the object, add is the command, type (for type of array) is an attribute
with
raid1 as the value of the attribute, and disk is another attribute with
0-1 as the value (ports 0 through 1).
Information about commands is organized by the object on which the
commands act:
Shell Object Commands. Shell object commands set the focus or provide
information (such as alarms, diagnostics, rebuild schedules, and so forth)
about all controllers in the system. For details, see “Shell Object Commands”
on page 19.
Controller Object Commands. Controller object commands provide
information and perform actions related to a specific controller. For example,
you use controller object commands for such tasks as seeing alarms specific
to a controller, creating schedules during which background tasks are run, and
setting policies for the controller. You also use the controller object command
/cx add type to create RAID arrays. For details, see “Controller Object
Commands” on page 25.
Unit Object Commands. Unit object commands provide information and
perform actions related to a specific unit on a specific controller. For example,
you use unit object commands for such tasks as seeing the rebuild, verify, or
initialize status of a unit, starting, stopping, and resuming verifies, starting
and stopping rebuilds, and setting policies for the unit. You also use the
controller object command /cx/ux migrate to change the configuration of a
RAID array. For details, see “Unit Object Commands” on page 53.