Filter
Top Products
8
Connecting MasterSwitch
VM
Caution
MasterSwitch
VM
does not provide power protection.
Therefore,
APC
does not recommend plugging the unit directly
into any unprotected power source, such as a wall outlet.
Setting up a
single unit
1. Connect the power cord of each device you wish to connect
to the outlets on the front of the unit.
2. Connect the
10
Base-
T
network port located on the rear
panel of the controller to the network, using an appropriate
cable.
3. Connect the
RJ-11
port labeled To
PDU
on the controller
front panel to the
RJ-11
port labeled In on the unit, using
the provided communication cable (
APC
part number
607-
0035A
).
4. Plug the unit into a protected power source.
Continued on next page