Filter
Top Products
11
Quick Configuration
continued
Configuring
TCP/IP settings,
continued
Through the Management Card Wizard. The MasterSwitch
VM
controller contains a management card that provides the
network interface. The Management Card Wizard provides a
quick way to configure all management card settings, including
TCP/IP settings. To access the Management Card Wizard, run
the program setup.exe on the CD-ROM supplied with
MasterSwitch
VM
on a Windows 95, Windows 98, or
Windows NT 4.0 workstation and follow the on-screen
instructions.
Serially through the Control Console. If you are not using a
Windows platform or require direct serial configuration, use
the Configuration port to configure MasterSwitch
VM
management card
TCP/IP
settings:
1. Connect the supplied configuration cable (
APC
part
number
940-0024
) to an available serial port on your
computer and to the Configuration port on the front
panel of the controller.
2. Disable PowerChute plus,
UNIX
Respond, or other
service that may be using the serial port on the
computer.
3. Run a terminal emulator such as, Windows
HyperTerminal.
4. Configure the appropriate serial port with the following
settings:
2400
bps, no parity, 8 data bits, 1 stop bit, and
no flow control.
Note: Some terminal emulators, such as
HyperTerminal, require that you disconnect and
reconnect in order for the new serial settings take
effect.
5. From your computer, press E
NTER
until the user name
prompt appears.
Continued on next page