Filter
Top Products
13
Quick Configuration
continued
Configuring
TCP/IP settings,
continued
Over the Network by ARP. (Address Resolution Protocol) To
configure MasterSwitch
VM TCP/IP
settings using
ARP
:
1. Connect the unit to the network.
2. From a command prompt on a computer connected to
the local subnet, type arp -s ip_addr_card
mac_card. See the example below:
arp -s 159.215.240.22 00-c0-b7-78-ad-
90
Note: The
MAC
address can be found on the Quality
Assurance slip, on the
TCP/IP
menu from the
Control Console, and on a sticker on the bottom
of the unit.
3. Type telnet ip_addr. See the example below:
telnet 159.215.240.22
The default user name and password are both apc. Configure
the correct Subnet Mask and default Gateway in the
TCP/IP
section of the Network menu.
Continued on next page