![](http://pdfasset.owneriq.net/e/44/e44aa57b-51e4-4dc2-a60d-33fca1a7d038/e44aa57b-51e4-4dc2-a60d-33fca1a7d038-bge.png)
10
Quick Configuration
Required
configuration
You must configure the network settings of MasterSwitch
VM
before it can operate on a network. The required settings are:
•
IP
address of MasterSwitch
VM
• Subnet Mask
•
IP
address of the default Gateway
After you have configured MasterSwitch
VM
network settings,
no further configuration is required. The remaining
MasterSwitch
VM
properties are pre-configured at the factory.
However, these properties may not be appropriate for your
application. See the chapter entitled “Managing MasterSwitch
VM
” in the User Guide (usrguide.pdf) for more details.
Configuring
TCP/IP settings
Choose the configuration method that matches your
environment:
• If you are using Windows™
95
,Windows
98
,or
Windows
NT
,see“Through the Management Card
Wizard” on page 11.
• If you are not using Windows or require direct serial
configuration, see “Serially through the Control
Console” on page 11.
• If you are a network administrator using
BOOTP
,see
“Over the Network by BOOTP” on page 12.
• If you are a network administrator and have access to a
computer connected to the local subnet, see “Over the
Network by ARP” on page 13
Continued on next page