Filter
Top Products
5
Installing MasterSwitch VM
continued
Mounting in a
NetShelter
enclosure,
continued
6. Insert two mounting screws (provided with the
enclosure) and secure the top bracket to the enclosure.
7. Insert two caged nuts above and below a notched hole
on the vertical mounting rail where the middle and
bottom brackets align with the rail.
8. Insert two mounting screws (provided with the
enclosure) where the middle and bottom brackets align
with the rail, and secure the brackets to the enclosure.
Mounting the
controller
To complete installation of MasterSwitch
VM
, install the
MasterSwitch
VM
Controller on a flat surface or in an
enclosure. To mount the controller in an enclosure:
1. Remove the rubber feet from the bottom of the
controller.
2. Attach the brackets (APC part numbers 870-8213 and
870-8183) to the controller using four flat-head screws
(provided).
Continued on next page