Filter
Top Products
UPS Display: Network Configuration Screens
Symmetra® MW with Internal Bypass Static Switch - User Guide - 990-1756A-001 17
• Apply Changes: Select this button after all changes have been made. All entries will appear in
red until Apply Changes is pressed.
• Send Test E-mail: When this button is pressed, a test E-mail is sent to all configured E-mail
recipients. This button can be used to validate the e-mail settings.
SNMP Settings screen
The UPS can be set to send SNMP traps if UPS alarm conditions occur, and when the conditions
return to normal afterwards. Each trap contains a description of the alarm condition. Up to 10 Trap
Receivers can be entered.
The Trap Receiver must have the APC PowerNet MIB (version 3.6.1 or later). The latest version of
the PowerNet MIB can be downloaded from www.apc.com.
• Enable SNMP: Enable the SNMP functionality by selecting this checkbox.
• To add a new Trap Receiver, touch the Add New button, type in the address and specify the
minimum severity of alarm.
• To edit or delete a Trap Receiver, select the recipient as they appear in the recipient list. Choose
to either update or delete the Trap receiver.
• Apply Changes: Select this button after all changes have been made. All entries will appear in
red until Apply Changes is pressed.
• Send Test SNMP: When this button is pressed, a test trap is sent to all configured Trap
Receivers. This button can be used to validate SNMP settings.
Note
Network Settings must be configured prior to configuring the SNMP Settings.
Normal
Normal
Network Configuration
SNMP Settings
5.34 PM
Page 3 of 5
Enable SNMP
Add new
Send Test SNMP
1 of 10 trap receivers
Informationalxxx.xxx.xxx.xx
Trap Receiver(s) Severity