Filter
Top Products
UPS Display: User Configuration Screens
Symmetra® MW with Internal Bypass Static Switch - User Guide - 990-1756A-001 21
Password Settings screen
Some of the UPS Display screens (primarily configuration screens) are protected by a password.
On installation the password is set to “apc.” For security reasons, it is recommended to change the
password.
• Enter current password: Enter the current password.
• Enter new password: Enter the new password.
• Re-enter the new password: Re-enter the password to validate the password.
Modbus Settings screen
The Modbus Settings screen allows monitoring of the UPS system by a Building Management
System (BMS).
Note
If you forget the password, contact your APC service representative who will be able to
help you.
Normal
Normal
User Configuration
Password Settings
5.39 PM
Page 2 of 5
Enter current password
Enter new password
Re- enter new password
Apply Changes
xxxx
xxxxxxxx
xxxxxxxx
Normal
Normal
User Configuration
Modbus Settings
5.39 PM
Page 3 of 5
BMS modbus RTU address
Communication Settings
Baud rate
Parity
Apply Changes
xxxx
xxxx
xxxx